Accessories

Elastic discahrge hoses intended for water and sewerage pumping.Fluid seal technology allow to seal rubber inside of the hose with polyester outside.Resistant to high temperature, pressure and hard to damage.
Hoses available in versions:
• In sackcloth braiding (firefighting hose) with quick-fit connectors, with maximum admissible pressure of 8 bar.
Application:
Water drainage from exacavations and flooded rooms, pumping out sewerage, water from lakes, ponds, rivers using submersible pumps

Automaton controlling operation of surface and deep well pumps with power up to 1100 W. It replaces the pressure switch and hydrophore tank. Opening the tap sends a signal to PC-15 automaton which starts the pump. Closing the tap makes PC-15 stop the pump. The automaton can match with one-phase pumps the power consumption of which does not exceed 12A during operation. The device provided with protection against dry run. When the well runs out of water, the devices stops the pump. The device equipped with a 60 cm long cable intended for connection to the pump and 1m long power cable. PC-15 is equipped with 1" diameter ports.

GFK - gravity backdraft damper to prevent air back draft in the system. Such fan configuration that includes KFK mixing chamber and GFK backdraft damper ensures fan motor overheating protection based on BY-PASS actuation, in particular when the motor is not running due to no power supply. This design enables backdraft damper shutting and hot air distribution to other premises through ventilation ducts when the motor is not running.

Motor speed controller RS-1-400 (under surface mounted) is used to control rotating speed of single - phase motors. It can be used in situation where the motor speed is governed by adjusting the effective voltage given to the winding.