Accessories

Brass regulators designed to regulate input pressure in water and air systems. They also protect the systems against pressure spikes. Compact size and low-noise operation. Pressure regulators are available in sets with pressure gauges.

Learn More

Square base made of acid-resistant steel is designed to protect the space around the chimney from adverse weather conditions, further simplifies the installation of the chimney cowl.

Learn More

The pressure switches are intended for automatic switch on and off of hydrophore sets together surface and deep well pumps equipped with an electric motor. The switches control the device operation, depending on the setting of on and off pressure parameters. The switches have a casing made of plastic, and the contacts are made of copper or silver. Learn More

Elastic discahrge hoses intended for water and sewerage pumping.Fluid seal technology allow to seal rubber inside of the hose with polyester outside.Resistant to high temperature, pressure and hard to damage.
Hoses available in versions:
• In sackcloth braiding (firefighting hose) with quick-fit connectors, with maximum admissible pressure of 8 bar.
Application:
Water drainage from exacavations and flooded rooms, pumping out sewerage, water from lakes, ponds, rivers using submersible pumps

Learn More

Automaton controlling operation of surface and deep well pumps with power up to 1100 W. It replaces the pressure switch and hydrophore tank. Opening the tap sends a signal to PC-15 automaton which starts the pump. Closing the tap makes PC-15 stop the pump. The automaton can match with one-phase pumps the power consumption of which does not exceed 12A during operation. The device provided with protection against dry run. When the well runs out of water, the devices stops the pump. The device equipped with a 60 cm long cable intended for connection to the pump and 1m long power cable. PC-15 is equipped with 1" diameter ports.

Learn More

GFK - gravity backdraft damper to prevent air back draft in the system. Such fan configuration that includes KFK mixing chamber and GFK backdraft damper ensures fan motor overheating protection based on BY-PASS actuation, in particular when the motor is not running due to no power supply. This design enables backdraft damper shutting and hot air distribution to other premises through ventilation ducts when the motor is not running.

Learn More

Motor speed controller RS-1-400 (under surface mounted) is used to control rotating speed of single - phase motors. It can be used in situation where the motor speed is governed by adjusting the effective voltage given to the winding.

Learn More

Turning fan on/off and speed switching for multispeed fans.

Learn More

If diameter of chimney is not 150/200/250/300 mm it can be connect with chimney cowl by force-in mounting chimney base which allows to connect Turbowent and Rotowent type cowls to a certain pipe chimney ending by pushing the base into the round duct.Base is made for order and delivery time is up to 14 days.

Learn More