IBOTRON deep well pump

IBOTRON series pumps are equipped with an automatic controller, eliminating the need for additional equipment such as a pressure switch or dry-run protection. The operating principle is based on sensors monitoring water flow. The pump starts automatically when the tap is turned on and shuts off within a few seconds when it is turned off. The pump has a built-in check valve to prevent water from flowing back from the system, as well as safety features such as overload, dry-run, and leak protection.
The pumped water must be free of mechanical impurities. The pump is designed for pumping water free of abrasive solids. Pumping water containing sand will lead to rapid pump wear and, consequently, pump failure. The pumped water must be free of long-fiber impurities. The pump is not suitable for pumping water containing excessive amounts of minerals, which cause scale buildup on the pumping elements. In this case, pump repair will only be possible on a paid basis. pH: 6.5–8.5

Built-in controller features:
• Water shortage protection
• Automatic start and stop of water circulation
• Overload protection
• Leakage protection

Applications:
• Pumping clean water from deep wells
• Increasing pressure in water supply systems when the unit is installed in a hermetic casing
• Use in farm water supply and irrigation
• Use in heat pump installations
• Water supply to industrial installations
• The pump is not suitable for use in gardens or swimming pools

Technical specifications:
• Max. liquid temperature: 35°C
• Power supply: 1~ 230 V / 50 Hz
• Insulation class: B
• Protection class: IP68
• Max. particle diameter: 0.4 kg/m3
• Max. rotational speed: 2850 RPM
• Max. immersion: 15 m
• Float: no
• Automatic: yes
• Cable type: H07RNF
• Power cable cross-section:
– 3 × 1 mm2 (60/90 – 80/90)
– 3 × 1.5 mm2 (100/90)
• Power cable length: 20 m
• Internal capacitor, no control box